168.

3ad aggregate.

In this video I show you how I configure LACP on a FortiGate 60E. set members "port4" "port5".

You don't have to assign it an IP address.

252.

Here is the config for the Fortigate redundant interface config system interface edit HA1_HA2. . Mar 12, 2021 · We will use fortigate firewall integrate with cisco core switch for inter vlan routing configuration.

The core switch is a single unit 6509 with multiple blades.

. set mode lacp-passive. 3.

. set description test.

Using the GUI: To configure the FortiLink interface on the FortiGate unit: Go to Network > Interfaces and click Create New.

http://www.

. 168.

. 2 255.

Complete the configuration as described in.
PCNSE.
Double-click the row for a physical interface to edit its configuration or click Add if you want to configure an aggregate or VLAN interface.

255.

Double-click the row for a physical interface to edit its configuration or click Add if you want to configure an aggregate or VLAN interface.

. 255. then assigned these port to subinterface.

Traditionally LAG is a trunking technology that groups together multiple full-duplex IEEE 802. 255. Fortigate Firewall - How to config Link Aggregation and the cisco switch commands are included. Created aggrate interface port3 & port 4. . Sep 13, 2021 · If I remove the single switch and run the pair of cables from the fortigate into the core then the FW fails and the ports on the core do not come up.

I connect it to a Cisco switch and test.

How to Setup Link #Aggregation LACP on #FortiGate #Firewall v7. I also show how to configure LACP on a UniFi switc.

To configure Trunk 2 on FortiSwitch 1: Configure the trunk 2 interface and assign member ports as a LAG group: config switch trunk.

Select + in the Interface members field and then select the ports to add to the FortiLink interface.

Check your link has come up on the Fortigate.

.

description ***uplink to fortinet internet fw***.